Oldham coupling (parallel-offset shaft coupling) — dimension sheet Source: Xem Studio, https://xemstudio.com/objects/oldham-coupling/ (sheet CC BY 4.0; files Xem Studio Design License, https://xemstudio.com/license/) Basis: Xem Studio drawing; classic mechanism Catalog version: 2026-10-20 Sizes: see table below - Resize: multiply every length by one factor k and the motion stays identical: angles, ratios, timing and the formulas below do not change, because a mechanism's motion depends only on the ratios of its lengths. Here, scales with k: diameter, max offset; step to the nearest standard size (and redraw the hole or pocket it fits): bores. - Resize: fit clearances stay in mm (a slide fit is the same gap at any size); keep every printed wall and pin at least two nozzle widths; mass grows with k³ but part strength only with k², so at k = 2 parts are about 8× heavier and 4× stronger: check pins and thin links when scaling up. - Two hubs with face tongues at 90° to each other and a centre disc slotted on both faces: the disc slides on both tongues, so shafts that are parallel but offset turn together. - Speed is exactly 1:1 (no cyclic error, unlike a universal joint); the disc centre orbits at twice shaft speed with a radius of half the offset. - Common on 3D-printer Z lead screws and pumps. - Parts (each has its own page): oldham-coupling-hub-40, oldham-coupling-disc-40, shaft-couplers. parameter value diameter 40 mm max offset ≈2 mm for this size bores Ø5 Files elsewhere (not hosted by Xem Studio; license as stated by the publisher): - Xem Studio: drawing — web — Publisher's page; dimensions are facts — https://xemstudio.com/ Free files (Xem Studio Design License, Xem Studio; STEP + STL, 1 parts): https://xemstudio.com/files/hardware/oldham-coupling/index.json API: https://xemstudio.com/api/geometry?object=oldham-coupling