Snap-in slot covers for 20, 30, 40, 45 mm and 1 in, 1.5 in T-slot extrusion (100 mm) — dimension sheet Source: Xem Studio, https://xemstudio.com/objects/t-slot-covers/ (sheet CC BY 4.0) Basis: Stem = slot opening wide and as deep as the lip (exact), snap barb 0.6 mm each side behind the lips (designed), cap 1.2 mm wider than the opening each side Catalog version: 2026-10-20 Sizes: see table below - Each cover is 100 mm long: a 1.2 mm cap on the face, a stem the slot opening wide down through the lip, and a 1 mm barb 1.2 mm wider than the opening (0.6 each side, designed) that springs behind the lips. On the inch series the stem runs to where the 2° drop-lock lip ends over the barb. - Covers hide wiring and keep debris out; the section is constant, so it can be extended to any length. family cap_mm stem_mm barb_mm 20-series (6 mm slot) 8.40 × 1.2 6.00 × 2.00 7.20 × 1 30-series (8 mm slot) 10.40 × 1.2 8.00 × 2.00 9.20 × 1 40-series (10 mm slot) 12.40 × 1.2 10.00 × 5.50 11.20 × 1 45-series (10 mm slot) 12.40 × 1.2 10.00 × 6.00 11.20 × 1 1 in 10-series 8.90 × 1.2 6.50 × 2.23 7.70 × 1 1.5 in 15-series 10.53 × 1.2 8.13 × 4.08 9.33 × 1 Files elsewhere (not hosted by Xem Studio; license as stated by the publisher): - Wikipedia: T-slot structural framing — web — CC BY-SA 4.0 (text) — https://en.wikipedia.org/wiki/T-slot_structural_framing - Wikipedia: T-slot nut — web — CC BY-SA 4.0 (text) — https://en.wikipedia.org/wiki/T-slot_nut Free files (CC BY 4.0, Xem Studio; STEP + STL, 6 parts): https://xemstudio.com/files/hardware/t-slot-covers/index.json API: https://xemstudio.com/api/geometry?object=t-slot-covers