Tri-clamp gasket, ISO 2852 Type B: 1.5 and 2 in — dimension sheet Source: Xem Studio, https://xemstudio.com/objects/tri-clamp-gasket/ (sheet CC BY 4.0) Basis: ISO 2852 Type B (Figure 3): web T1 1.7, a bulge each side on the groove diameter (U 5.5 overall, R5 1.2, R4 0.4), inner lip T4 1.1 × T2 2.8; measured from the files Catalog version: 2026-10-20 Sizes: see table below - The Type B gasket between two ISO 2852 faces: a 1.7 mm web on the flat faces, a bulge on each side centred on the groove diameter that sits in each face's gasket groove (5.5 mm over both; each 1.9 proud of the web in a 1.6 deep groove, so 0.3 squeeze each side, designed), and an inner lip into the bore. - 2 in: OD Ø63.0, bulges on Ø56.5, lip ID Ø45.3. 1.5 in: OD Ø49.5, bulges on Ø43.5, lip ID Ø32.6. The lip is 1.1 mm thick radially inside the bore and 2.8 mm long, centred on the joint plane: 0.55 mm past each face. The published gasket ID (2 in 47.7, 1.5 in 35.0) is the web's ID where the lip starts. - The sanitary-clamp gasket page carries the same profile for every size ½ to 4 in. size_in od_mm bulge_on_dia_mm web_id_mm lip_id_mm overall_mm web_mm lip_length_mm 1.5 49.5 43.5 35.0 32.6 5.5 1.7 2.8 2 63.0 56.5 47.7 45.3 5.5 1.7 2.8 Files elsewhere (not hosted by Xem Studio; license as stated by the publisher): - L.J. Star: Sanitary clamp gaskets: a good seal compresses the gasket about 0.3 mm — web — maker page [verify license at link] — https://www.ljstar.com/ - Rubber Fab: Tri-Clamp gasket dimensional chart: gasket ID, OD and bead diameter per size (2 in bead 2.22 in / 56.50 mm, 1.5 in 1.71 / 43.50, 3 in 3.29 / 83.50) — PDF — maker chart; dimensions are facts [verify license at link] — https://shop.andersonprocess.com/media/assets/product/documents/rubber-fab-tri-clamp-dimensions.pdf - ISO (via iTeh sample): ISO 2852:1974 clamp liners with gaskets (face and gasket profile, §6.1 and §8) — PDF — standard excerpt; dimensions are facts — https://cdn.standards.iteh.ai/samples/7850/eb49c396488d408c8ced3e2961d76cf3/ISO-2852-1974.pdf - McMaster-Carr: Sanitary caps and gaskets (free STEP per part, for your own design use; no redistribution) — STEP, PDF — McMaster-Carr site terms: personal design use, no redistribution [verify license at link] — https://www.mcmaster.com/products/sanitary-fittings/ Free files (CC BY 4.0, Xem Studio; STEP + STL, 2 parts): https://xemstudio.com/files/hardware/tri-clamp-gasket/index.json API: https://xemstudio.com/api/geometry?object=tri-clamp-gasket