Tri-clamp half gasket for a clamped leaf or rim: 2 in, web 0.6 or 0.45 — dimension sheet Source: Xem Studio, https://xemstudio.com/objects/tri-clamp-leaf-half-gasket/ (sheet CC BY 4.0) Basis: ISO 2852 Type B section split at the joint plane: one bulge (R5 1.2, R4 0.4, 1.9 above the web) in one face's 1.6 deep gasket groove with the Type B's 0.3 squeeze, web so that two webs and the plate make the 1.7 joint Catalog version: 2026-10-20 Sizes: see table below - Two of them sandwich a flat plate (a flexure leaf, the liner's rim) in a 2 in joint: each bulge sits in its ferrule's gasket groove, each web lies on the flat face, the plate between the webs. Web 0.6 for a 0.5 plate, 0.45 for a 0.8 plate: 0.6 + 0.5 + 0.6 = 0.45 + 0.8 + 0.45 = 1.7, the Type B web, so the clamp closes as usual. - Ratings, as facts: the gasket must be rated above the relief setting (15 bar gauge) at its temperature; helium permeates silicone faster than PTFE; PTFE cold-flows under sustained load and heat. Cut or ordered to this drawing. web_mm plate_mm bulge_above_web_mm bulge_on_dia_mm od_mm id_mm 0.6 0.5 1.9 56.5 63 47.5 0.45 0.8 1.9 56.5 63 47.5 Files elsewhere (not hosted by Xem Studio; license as stated by the publisher): - ISO (via iTeh sample): ISO 2852 clamp liners: face profile and flange / groove diameters — PDF — standard excerpt; dimensions are facts — https://cdn.standards.iteh.ai/samples/7850/eb49c396488d408c8ced3e2961d76cf3/ISO-2852-1974.pdf - ASME: BPE Bioprocessing Equipment (tube OD and wall, clamp fittings) — standard — ASME; dimensions are facts [verify license at link] — https://www.asme.org/codes-standards/find-codes-standards/bpe-bioprocessing-equipment - Long Earth Society: Engine builds — web, video — LES site — https://longearthsociety.com/engineering/ Free files (CC BY 4.0, Xem Studio; STEP + STL, 2 parts): https://xemstudio.com/files/hardware/tri-clamp-leaf-half-gasket/index.json API: https://xemstudio.com/api/geometry?object=tri-clamp-leaf-half-gasket